|
|
|
|
 |
Pellet Pipe 243810 Storm Collar, 3 in Pipe, Galvanized
|
|

Type L pellent vent storm collar used at the top of the flashing to assist in shedding water from the assembly.
|
|
 |
|
|
|
|
 |
Selkirk 243430 Tee Support, For Use with VP Pellet Pipe, 3/4 in
|
|

Type L pellet vent. Can be used to support either a 3" or 4" diameter tee installation. UL Listed.
|
|
 |
|
|
|
|
 |
Selkirk 243502 Trim Plate, For Use with VP Pellet Pipe, 3 in Dia, Painted Black
|
|

Used to finish off the bottom (ceiling) side of a floor/ceiling penetration or on the outside wall as a exterior shield. Over-all size is 12-1/2" x 12-1/2". UL Listed.
|
|
 |
|
|
|
|
 |
Selkirk 243520 Wall Bracket, 3 in
|
|

For use on the exterior to support pipe to wall. Use only with Selkirk pellet stove pipe. Hold pipe 3" from wall. UL Listed.
|
|
 |
|
|
|
|
 |
Selkirk 243243 Adjustable Pipe Connector, 3 in
|
|

Adjustable pipe connector will connect to 3" appliance outlet and is securely fastened with a hose clamp, while the male end adapts to the standard inlet end of 3" VP pipe, elbow or tee. UL Listed.
|
|
 |
|
|
|
|
 |
Selkirk A 243825 Adjustable Pellet Vent Roof Flashing, Galvanized Steel
|
|

Type L pellet vent. Flashings are used for keeping water and other debris from entering between the pipe and roof. Adjustable pitch. UL Listed.
|
|
 |
|
|
|
|
 |
Pellet Pipe 243800 Vertical Termination Stove Pipe Cap 8 in OD, Galvanized
|
|

Vertical round top/termination cap. Type L pellet vent. Cap provides necessary protection of the vent system from rain and other elements. UL Listed.
|
|
 |
|
|
|
|
 |
Pellet Pipe 243215 Type L Vent Stove Pipe Elbow, 3 in, 45 deg, 570 deg F, Black
|
|

Used to offset pipe around construction obstacles. Factory sealed at couplers to prevent leakage.
|
|
 |
|
|
|
|
 |
Pellet Pipe 243803 Exit Stove Pipe Cap 5-3/4 in L, Galvanized
|
|

Exit Cone Cap is designed to direct flue gases perpendicular to the wall and to increase their velocity, projecting them further away from the building. UL Listed.
|
|
 |
|
|
|
|
 |
Pellet Pipe 243230 Type L Vent Stove Pipe Elbow, 3 in, 90 deg, 570 deg F, Galvanized
|
|

Type L vent systems for pellet stove applications.Used to orient pipe between vertical and horizontal orientation. Rated for flue temperatures up to 570 degrees F. Model VP may be installed with a minimum 1" air space clearance to combustible surfaces, framing lumber, drywall, and plywood. UL Listed.
|
|
 |